Note

Note:

 

A battery charged with liquid factory, not attempt to remove the battery to avoid the risk. If accidentally using the battery case is damaged, contact sulfuric acid, please rinse with plenty of water, seek medical attention immediately if necessary;

 

2, can not mix old and new batteries;

 

3, can not use the battery in a sealed container;

 

4, the battery should be complete resume, including the date of manufacture, installation date, the use of case records;

 

5, regularly (once a year) to check the connection is loose, if there is loosening, and should be tightened;

 

6, regularly (every three months) wipe with a soft fabric batteries, so that the battery to keep clean;

 

7 Do not use organic solvents to clean the battery;

 

8. Note that the battery isolation to prevent salt bridge generation.

Battery connector:

 

Same actual capacity of the battery or batteries in series before use;

 

The actual voltage of the battery or battery pack the same series before use;

 

Joints to be tight to prevent sparks. If exposed, available water to clean the contact surface;

 

Positive and negative can not be reversed or short;

 

Should the interval between the battery pack has more than 10MM, to facilitate heat dissipation.

 

Battery charging:

 

Floating use (limit voltage control current): charging voltage 2.275-2.30V / single cell (25 ℃);

 

Temperature compensation, temperature compensation coefficient per monomer 3MV / ℃ (in 20 ℃ basis);

 

When trickle use, the battery float current is adjusted to less than 2MA / AH;

 

Recycling (fully charged that the stop, put the electricity that charge): charging voltage 2.35-2.45V / single cell;

 

The maximum current is not greater than 25% of the nominal capacity;

 

Note: The battery can not be used in enclosed or high temperature environments, away from sources of ignition.

 

Storage and installation:

 

1, the battery is not in use should remove the cable, pole jacket cover and wipe clean;

 

2, once every three months for the battery to maintain charging, constant voltage charging method for limiting law, the initial charging current is 0.1CA, the charging voltage is 2.4V / single cell (25 ℃ when);

 

3, the battery should be stored in dry and ventilated place, away from direct sunlight and away from heat sources;

 

4, when handling batteries even force, the force of the housing portion of the battery to avoid damage to the pole;

 

5, the installation should use insulated tools to prevent click.

 

Note:

 

A battery charged with liquid factory, not attempt to remove the battery to avoid the risk. If accidentally using the battery case is damaged, contact sulfuric acid, please rinse with plenty of water, seek medical attention immediately if necessary;

 

2, can not mix old and new batteries;

 

3, can not use the battery in a sealed container;

 

4, the battery should be complete resume, including the date of manufacture, installation date, the use of case records;

 

5, regularly (once a year) to check the connection is loose, if there is loosening, and should be tightened;

 

6, regularly (every three months) wipe with a soft fabric batteries, so that the battery to keep clean;

 

7 Do not use organic solvents to clean the battery;

 

8. Note that the battery isolation to prevent salt bridge generation.

 

 

Conditions of use and the environment

1. The charging current (float use): 0.15CA following

2. Discharge current range: 0.05CA ~ 3CA

3. Ambient temperature: 0 ℃ ~ 40 ℃ (suitable temperature is 25 ℃)

4. Charge voltage: (12V battery recommended)

Ambient temperature

 

Charging voltage (float use)

 

Discharge voltage (float use)

25 ℃

 

13.60 to 13.80V

 

10.5V

   Notes: 1. When using the float, when the charge current exceeds 0.15CA, please consult in advance with the company.

    2.0.15CA = 0.15 × battery capacity, 0.05CA and 3CA so on.

   Storage charging conditions

Storage temperature range is -15 ℃ ~ 40 ℃, the battery should be regularly supplementary charge: no charge during the relationship and be able to keep the temperature as follows:

        Below 20 ℃: 9 months

        The following 20 ~ 30 ℃: 6 months

        30 ~ 40 ℃ following: 3 months

   Installation Notes

    (1) by vertically upright placement principle, prohibit the use of battery upside down.

    (2) Do not give abnormal vibration and impact on the battery.

    (3) During the installation should pay attention to insulation.

    (4) Do not install the machine into a closed-shaped structure.

    (5) During the installation process should pay attention to make to maintain a certain distance between the battery, in order to ensure air circulation.

    (6) Please do not mix different types of batteries.

    (7) Do not let the battery contact with organic solvents.

     Cautions

    (1) Make sure the conditions are met factory specifications.

    (2) the initial use or long-term use must be charged after placement.

    (3) UPS batteries are used for float use, if you frequently use the battery (similar recycling), it will seriously affect the battery trickle

       Life.

    (4) regular battery checks.

    (5) found the groove deformation and electrical leakage phenomenon, please do not use, should be replaced.

    (6) If the connection is not tight at the terminals, posing a risk of fire.

    (7) If there is no power outages can recommend three to six months to do a discharge, such as found in the battery charging voltage or discharge characteristics, which are abnormal, please

       Replace the batteries.

    (8) the battery capacity is less than 10% of the initial capacity of the battery should be replaced.